Reset service light on Volkswagen Jetta car using XTOOL A80 Pro (H6 Pro) with VCI box. Main steps: The device used is XTOOL H6 Pro. But the guide also applied to A80 Pro. Connect XTOOL VCI to the vehicle via main cable, and connect to XTOOL tablet via Bluetooth Go to the “Diagnosis” function Select Service/Maintenance-> EUROPE-> VW/AUDI/SEAT/SKODA-> Autoreset-> Autoset There are two options that can be selected: Small service and Big service
Here select a small service to reset Then you also can see two maintenance modes: Normal maintenance and Special maintenance. Here select Normal maintenance to do There are four options that can be performed as follows: 5000Km/180Day Just choose the one you desire to do, here we select 7500Km/180Day to try Setup is successful. Note: If the dashboard display still prompts maintenance (service), please set small maintenance.
0 Comments
One consumer wrote that Xentry Does not accept the key.(Startkey is invaild) In the Mercedes-Benz folder, open ConfigAssist Disconnect the internect and press configuration Next+Next Click Mannually and insert Click Save and here’s the error, Supplied Startkey is invalid Many People had such an error We reboot the computer and enter the BIOS. Either the F2 button or Delete Secure Boot – Disabled Save Changes
In the folder that you downloaded, open the Xentry Developer file Copy + Paste 2021.01.01 and 2025.01.01 Click Generate Click Mannually and insert Save + OK + Apply and continue Xentry Works. You can do the same for Xentry 2016,2018,2020,2021
|
Archives
February 2022
类别 |